|
-
-
Violation: Ice machine
Food contact surface not clean to sight and/or touch
Code Reference:
(4-601.11) (A) EQUIPMENT FOOD-CONTACT SURFACES and UTENSILS shall be clean to sight and touch.
Corrected on site by cleaning the ice machine
-
-
Violation: Plastic cups
Single service items stored on the floor/not stored in clean dry location
Code Reference:
(4-903.11) (A) Except as specified in ¶ (D) of this section, cleaned EQUIPMENT and UTENSILS, laundered LINENS, and SINGLE-SERVICE and SINGLE-USE ARTICLES shall be stored:
(1) In a clean, dry location;
(2) Where they are not exposed to splash, dust, or other contamination; and
(3) At least 15 cm (6 inches) above the floor.
(B) Clean EQUIPMENT and UTENSILS shall be stored as specified under ¶ (A) of this section and shall be stored:
(1) In a self-draining position that allows air drying; and
(2) Covered or inverted.
(C) SINGLE-SERVICE and SINGLE-USE ARTICLES shall be stored as specified under ¶ (A) of this section and shall be kept in the original protective PACKAGE or stored by using other means that afford protection from contamination until used.
(D) Items that are kept in closed PACKAGES may be stored less than 15 cm (6 inches) above the floor on dollies, pallets, racks, and skids that are designed as specified under § 4-204.122.
-
-
Violation:
Improper valve connected to mop sink faucet
Code Reference:
(5-203.14) A PLUMBING SYSTEM shall be installed to preclude backflow of a solid, liquid, or gas contaminant into the water supply system at each point of use at the FOOD ESTABLISHMENT, including on a hose bibb if a hose is attached or on a hose bibb if a hose is not attached and backflow prevention is required by LAW, by:
(A) Providing an air gap as specified under § 5-202.13; or
(B) Installing an APPROVED backflow prevention device as specified under § 5-202.14.
-
|
ROUTINE INSPECTION