|
-
-
Observed hand sink blocked by trash can upon arrival. (Corrected on site, trash can moved)
(5-205.11) (A) A HANDWASHING SINK shall be maintained so that it is accessible at all times for EMPLOYEE use.
(B) A HANDWASHING SINK may not be used for purposes other than handwashing. (C) An automatic handwashing facility shall be used in accordance with manufacturer=s instructions.
-
-
Observed torn gasket on reach-in-cooler door.
(4-501.11) (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 and 4-2.
(B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications.
(C) Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate FOOD when the container is opened.
-
-
Observed sanitizer buckets with too low chlorine concentration. (Corrected on site, buckets remade to correct concentration.)
(3-304.14) Cloths in-use for wiping counters and other EQUIPMENT surfaces shall be:
(1) Held between uses in a chemical sanitizer solution at a concentration specified under § 4-501.114; and
(2) Laundered daily as specified under ¶ 4-802.11(D).
-
-
Observed containers of food sitting directed on top of other food items in make table. (Corrected on site, items removed)
(3-305.11) (A) Except as specified in ¶¶ (B) and (C) of this section, FOOD shall be protected from contamination by storing the FOOD:
(1) In a clean, dry location;
(2) Where it is not exposed to splash, dust, or other contamination; and
(3) At least 15 cm (6 inches) above the floor.
(B) FOOD in packages and working containers may be stored less than 15 cm (6 inches) above the floor on case lot handling EQUIPMENT as specified under § 4-204.122.
(C) Pressurized BEVERAGE containers, cased FOOD in waterproof containers such as bottles or cans, and milk containers in plastic crates may be stored on a floor that is clean and not exposed to floor moisture.
|
|
-
-
Observed walk-in-cooler gasket damaged.
(4-501.11) (A) EQUIPMENT shall be maintained in a state of repair and condition that meets the requirements specified under Parts 4-1 and 4-2.
(B) EQUIPMENT components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications.
(C) Cutting or piercing parts of can openers shall be kept sharp to minimize the creation of metal fragments that can contaminate FOOD when the container is opened.
|