Date
|
Inspection Type
|
Score
|
Expand All
|
12/01/2023
|
ROUTINE INSPECTION
|
98%
|
|
-
-
Observed heavy ice build-up on ceiling of walk-in freezer.
(4-602.13)NonFOOD-CONTACT SURFACES of EQUIPMENT shall be cleaned at a frequency necessary to preclude accumulation of soil residues.
-
-
Chemical dispenser attached to mop sink faucet.
Valved Y-attachment connected to mop sink faucet.
(5-205.15)A PLUMBING SYSTEM shall be:
(A) Repaired according to LAW; and
(B) Maintained in good repair
|
10/12/2022
|
ROUTINE INSPECTION
|
100%
|
|
|
11/16/2021
|
3RD FOLLOW UP INSPECTION
|
98%
|
|
-
-
Observed flying gnats at produce section. A Notice of Violation will be issued.
(6-501.111) The presence of insects, rodents, and other pests shall be controlled to minimize their presence on the PREMISES by:
(A) Routinely inspecting incoming shipments of FOOD and supplies;
(B) Routinely inspecting the PREMISES for evidence of pests;
(C) Using methods, if pests are found, such as trapping devices or other means of pest control as specified under §§ 7-202.12, 7-206.12, and 7-206.13;
(D) Eliminating harborage conditions.
|
11/09/2021
|
FOLLOW UP INSPECTION
|
98%
|
|
-
-
Observed gnats flying around produce section. Follow up 11/16/21
(6-501.111) The presence of insects, rodents, and other pests shall be controlled to minimize their presence on the PREMISES by:
(A) Routinely inspecting incoming shipments of FOOD and supplies;
(B) Routinely inspecting the PREMISES for evidence of pests;
(C) Using methods, if pests are found, such as trapping devices or other means of pest control as specified under §§ 7-202.12, 7-206.12, and 7-206.13;
(D) Eliminating harborage conditions.
|
10/28/2021
|
ROUTINE INSPECTION
|
96%
|
|
-
-
Observed Gnats flying around veggie/ fruit aisle. Follow up 11/8/21.
(6-501.111) The presence of insects, rodents, and other pests shall be controlled to minimize their presence on the PREMISES by:
(A) Routinely inspecting incoming shipments of FOOD and supplies;
(B) Routinely inspecting the PREMISES for evidence of pests;
(C) Using methods, if pests are found, such as trapping devices or other means of pest control as specified under §§ 7-202.12, 7-206.12, and 7-206.13;
(D) Eliminating harborage conditions.
-
-
Observed no thermometers inside of walk in cooler.
(4-204.112) (A) In a mechanically refrigerated or hot FOOD storage unit, the sensor of a TEMPERATURE MEASURING DEVICE shall be located to measure the air temperature or a simulated product temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot FOOD storage unit.
(B) Except as specified in ¶ (C) of this section, cold or hot holding EQUIPMENT used for POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL FOR SAFETY FOOD) shall be designed to include and shall be equipped with at least one integral or permanently affixed TEMPERATURE MEASURING DEVICE that is located to allow easy viewing of the device's temperature display.
(C) Paragraph (B) of this section does not apply to EQUIPMENT for which the placement of a TEMPERATURE MEASURING DEVICE is not a practical means for measuring the ambient air surrounding the FOOD because of the design, type, and use of the EQUIPMENT, such as calrod units, heat lamps, cold plates, bainmaries, steam tables, insulated FOOD transport containers, and salad bars.
(D) TEMPERATURE MEASURING DEVICES shall be designed to be easily readable.
(E) FOOD TEMPERATURE MEASURING DEVICES and water TEMPERATURE MEASURING DEVICES on WAREWASHING machines shall have a numerical scale, printed record, or digital readout in increments no greater than 1oC or 2oF in the intended range of use.
-
-
Observed food items and cardboard on the floor underneath racks inside of walk in cooler.
(6-501.12)(A) PHYSICAL FACILITIES shall be cleaned as often as necessary to keep them clean.
(B) Except for cleaning that is necessary due to a spill or other accident, cleaning shall be done during periods when the least amount of FOOD is exposed such as after closing.
|