Date
|
Inspection Type
|
Score
|
Expand All
|
04/02/2024
|
ROUTINE INSPECTION
|
96%
|
|
-
-
No date marking system in place for ready to eat potentially hazardous foods
COS employee to date mark items in the reach in cooler
(3-501.17)Refrigerated, READY-TO-EAT, POTENTIALLY HAZARDOUS FOOD (TIME/TEMPERATURE CONTROL
FOR SAFETY FOOD) prepared and held in a FOOD ESTABLISHMENT for more than 24 hours shall be clearly marked to indicate the date or day by which the FOOD shall be consumed on the PREMISES, sold, or discarded
-
-
Chemical spray bottles not labeled and/or not properly labeled
COS employee labeled chemical spray bottle
(7-102.11) Working containers used for storing POISONOUS OR TOXIC MATERIALS such as cleaners and SANITIZERS taken from bulk supplies shall be clearly and individually identified with the common name of the material
-
-
Ceiling in food prep area not smooth, durable, nonabsorbent, and easily cleanable
Observed ceiling damage above the prep area
(6-101.11) (A) Except as specified in ¶ (B) of this section, materials for indoor floor, wall, and ceiling surfaces under conditions of normal use shall be:
(1) SMOOTH, durable, and EASILY CLEANABLE for areas where FOOD ESTABLISHMENT operations are conducted;
(2) Closely woven and EASILY CLEANABLE carpet for carpeted areas; and
(3) Nonabsorbent for areas subject to moisture such as FOOD preparation areas, walk-in refrigerators, WAREWASHING areas, toilet rooms, mobile FOOD ESTABLISHMENT SERVICING AREAS, and areas subject to flushing or spray cleaning methods.
-
-
Test kits not available to measure sanitizer concentration
(4-302.14)A test kit or other device that accurately measures the concentration in MG/L of SANITIZING solutions shall be provided.
-
-
No thermometer provided in refrigerators/hot holding units
(4-302.12) (A) FOOD TEMPERATURE MEASURING DEVICES shall be provided and readily accessible for use in ensuring attainment and maintenance of FOOD temperatures as specified under Chapter 3.
(B) A TEMPERATURE MEASURING DEVICE with a suitable small diameter probe that is designed to measure the temperature of thin masses shall be provided and readily accessible to accurately measure the temperature in thin FOODS such as MEAT patties and FISH filets.
-
-
Intensity not at least 75 foot candles (807 lux)
(6-303.11) The light intensity shall be:
(A) At least 20 foot candles (215 lux) (lux = lumen/square meter) at a distance of 75 cm (30 inches) above the floor, in walk-in refrigeration units, dry FOOD storage areas, in other areas, and rooms during periods of cleaning.
(B) At least 40 foot candles (430 lux):
(1) At a surface where FOOD is provided for CONSUMER self-service such as buffets and salad bars or where fresh produce or PACKAGE FOODS are sold or offered for consumption; and
(2) Inside equipment such as reach-in and under-counter refrigerators; and
(3) At a distance of 30 inches above the floor in areas used for hand-washing, WAREWASHING, and EQUIPMENT
and UTENSIL storage, and in toilet rooms.
(C) At least 75 foot candles (807 lux) at a surface where a FOOD EMPLOYEE is working with FOOD or working with UTENSILS or EQUIPMENT such as knives, slicers, grinders, or saws where EMPLOYEE safety is a factor.
|
10/13/2023
|
ROUTINE INSPECTION
|
98%
|
|
-
-
Handwashing sink not accessible or being used for purposes other than hand washing
COS employee moved item blocking handsink
(5-205.11) (A) A HANDWASHING SINK shall be maintained so that it is accessible at all times for EMPLOYEE use.
(B) A HANDWASHING SINK may not be used for purposes other than handwashing. (C) An automatic handwashing facility shall be used in accordance with manufacturer=s instructions.
-
-
Manual and mechanical warewashing sanitizer concentration is high
COS employee made sanitizer in the 3 comp sink the the correct chlorine concentration
(4-501.114) A chemical SANITIZER used in a SANITIZING solution for a manual or mechanical operation at exposure times specified under ¶ 4-703.11(C) shall meet the criteria specified under § 7-204.11 Sanitizers, Criteria, shall be used in accordance with the EPA approved manufacturer's label use instructions, and shall be
used as follows:
(A) A chlorine solution shall have a minimum temperature based on the concentration and PH of the solution as listed in the following chart;
Minimum Concentration Minimum Temperature
MG/L pH 10 or less °C (°F) pH 8 or less °C (°F)
25 49 (120) 49 (120)
50 38 (100) 24 ( 75)
100 13 ( 55) 13 ( 55)
(B) An iodine solution shall have a:
(1) Minimum temperature of 24°C (75°F),
(2) pH of 5.0 or less or a PH no higher than the level for which the manufacturer specifies the solution is
effective, and
(3) Concentration between 12.5 MG/L and 25 MG/L;
(C) A quaternary ammonium compound solution shall:
(1) Have a minimum temperature of 24°C (75°F),
(2) Have a concentration as specified under ' 7-204.11 and as indicated by the manufacturer's use directions
included in the labeling, and
(3) Be used only in water with 500 MG/L hardness or less or in water having a hardness no greater than specified by the manufacturer's label;
(D) If another solution of a chemical specified under && (A) - (C) of this section is used, the PERMIT HOLDER shall demonstrate to the REGULATORY AUTHORITY that the solution achieves SANITIZATION and the use of the solution shall be APPROVED; or
(E) If a chemical SANITIZER other than chlorine, iodine, or a quaternary ammonium compound is used, it shall be applied in accordance with the manufacturer’s use directions included in the labeling.
-
-
No thermometer provided in refrigerators/hot holding units
(4-302.12) (A) FOOD TEMPERATURE MEASURING DEVICES shall be provided and readily accessible for use in ensuring attainment and maintenance of FOOD temperatures as specified under Chapter 3.
(B) A TEMPERATURE MEASURING DEVICE with a suitable small diameter probe that is designed to measure the temperature of thin masses shall be provided and readily accessible to accurately measure the temperature in thin FOODS such as MEAT patties and FISH filets.
-
-
Observed ceiling damage above the ware washing area
(6-101.11) (A) Except as specified in ¶ (B) of this section, materials for indoor floor, wall, and ceiling surfaces under conditions of normal use shall be:
(1) SMOOTH, durable, and EASILY CLEANABLE for areas where FOOD ESTABLISHMENT operations are conducted;
(2) Closely woven and EASILY CLEANABLE carpet for carpeted areas; and
(3) Nonabsorbent for areas subject to moisture such as FOOD preparation areas, walk-in refrigerators, WAREWASHING areas, toilet rooms, mobile FOOD ESTABLISHMENT SERVICING AREAS, and areas subject to flushing or spray cleaning methods.
|
04/06/2023
|
ROUTINE INSPECTION
|
98%
|
|
-
-
Observed damage to a ceiling tile above the ware washing area
(6-101.11) (A) Except as specified in ¶ (B) of this section, materials for indoor floor, wall, and ceiling surfaces under conditions of normal use shall be:
(1) SMOOTH, durable, and EASILY CLEANABLE for areas where FOOD ESTABLISHMENT operations are conducted;
(2) Closely woven and EASILY CLEANABLE carpet for carpeted areas; and
(3) Nonabsorbent for areas subject to moisture such as FOOD preparation areas, walk-in refrigerators, WAREWASHING areas, toilet rooms, mobile FOOD ESTABLISHMENT SERVICING AREAS, and areas subject to flushing or spray cleaning methods.
-
-
Kitchenware/Tableware not stored/handled/dispensed/displayed to protect food/lip contact surfaces
Observed utensils handles not all the same direction
(4-904.11) (A) SINGLE-SERVICE and SINGLE-USE ARTICLES and cleaned and SANITIZED UTENSILS shall be handled, displayed, and dispensed so that contamination of FOOD- and lip-contact surfaces is prevented.
(B) Knives, forks, and spoons that are not prewrapped shall be presented so that only the handles are touched by EMPLOYEES and by CONSUMERS if CONSUMER self-service is provided.
(C) Except as specified under ¶ (B) of this section, SINGLESERVICE ARTICLES that are intended for FOOD- or lip-contact shall be furnished for CONSUMER self-service with the original individual wrapper intact or from an APPROVED dispenser.
|
10/05/2022
|
ROUTINE INSPECTION
|
96%
|
|
-
-
4-601.11 No sanitizer set up to sanitize food contact surfaces
|
12/22/2021
|
ROUTINE INSPECTION
|
100%
|
|
|